Tuning In The Group Of User Transponders - Sygonix 1717531 Bedienungsanleitung

j) Tuning in the group of user transponders
Chapter 9. i) describes how you can tune in individual transponders (without entering a user
code) in operating mode 1. However, if you would like to tune in a larger number of transponders
(e.g. 50 transponders for many authorised employees), the code lock offers a special function
for this purpose.
No user code can be entered during the tuning in process. Therefore, this function can
only be used for operating mode 1 (activation of the output only via the transponder).
Proceed as follows:
• Enable the programming mode; see chapter 9. a).
• Enter . The control LED will flash yellow.
• Enter . The code lock will emit a long sound signal and the control LED will glow
yellow steadily.
• Enter a memory number from which the transponders are to be stored (possible
..... ). The code lock will emit a long sound signal.
Example:
If you want to tune in, for example, 50 transponders and enter the memory number
from
Make sure that all storage devices are empty.
• Enter the number of transponders that you want to tune in successively.
The number must always be entered as a 3-digit number.
Example: tune in 50 transponders = enter
• If you want to cancel the tuning in process, briefly press the
• Now hold the first transponder in front of the code lock. Once the transponder has been
detected, the code lock will emit a short sound signal. Then you will hear a long sound signal,
which means that the transponder has been tuned in.
Then proceed in the same way for all other transponders to be tuned in.
• Once all transponders have been tuned in, briefly press the
ming mode. The control LED will glow red steadily.
46
as the start number, 50 transponders will be tuned in to 50 storage devices
to .
button.
button to exit the program-