G) Creating The Master Transponder; H) Calling Up The Programming Mode With A Master Transponder - Sygonix 1717531 Bedienungsanleitung

g) Creating the master transponder

The programming mode of the code lock can be enabled with a master transponder. It simplifies
or speeds up the operation, especially in the event of a long master code or frequent program-
ming of the code lock.
Only one master transponder can be tuned in to the code lock at a time. If the master
transponder is damaged or lost, a new transponder can naturally be tuned in as a
master transponder.
Proceed as follows:
• Enable the programming mode; see chapter 9. a).
• Enter .
• The control LED indicates whether a master transponder has already been tuned in:
- LED flashes green: No master transponder has been tuned in
- LED glows red steadily: Master transponder has already been tuned in
• If you want to cancel the tuning in process, briefly press the
• If you want to delete an already tuned in master transponder, briefly press the
twice. Then the control LED will flash green and a new master transponder can be created;
see next step.
• To have a transponder tuned in as a master transponder, just hold it in front of the code lock.
• Once the transponder has been detected, the code lock will emit a short sound signal. Then
you will hear a long sound signal, which means that the transponder has been tuned in as a
master transponder. The control LED will glow yellow steadily.
• Press the button to exit programming mode. The control LED will glow red steadily.

h) Calling up the programming mode with a master transponder

To call up the programming mode with a master transponder, just hold it in front of the code lock.
Once the master transponder has been detected, the code lock will emit a long sound signal and
the control LED will glow yellow steadily.
You can now proceed with the programmings as usual.
In addition to exiting the programming mode with the
master transponder in front of the code lock.
button.
button, you can also hold the
button
43