Setup - Sygonix 1717531 Bedienungsanleitung

8. Setup

• Once you have finished mounting the product (see section 7 for details), turn on the power
supply.
• The illumination of the buttons will be enabled. The control LED at the top of the code lock will
flash for about 5 seconds and will then glow steadily.
• You can now start programming; see chapter 9.
To enable the programming mode, the master code (or a tuned in master transponder)
is always required. By default, the master code is
anyway for the normal operation of the code lock.
Important!
If you have forgotten the master code you have programmed, proceed as described in
chapter 9. b).
Warning!
Master code and user codes can include 2 to 6 digits. All codes must be of the same
length.
All data or programmings will be retained even in the event of a power cut.
We recommend that you proceed with programming in the following order:
• Reset the code lock to the factory settings
• Select the operating mode of the code lock
• Programme the code length and the new master code
• If transponders are to be used: create a master transponder
• Programme user codes and/or tune in the user transponder
• Programme the activation time for the changeover contact
• Turn on the bell function, if desired
36
; it must be changed