Sygonix 1717531 Bedienungsanleitung Seite 45

Tuning in the transponder and entering the user code (for operating modes 2 and 3):
If operating mode 2 has been set, the changeover contact can be enabled via the
transponder or the user code.
In operating mode 3, both a transponder and the user code are required to enable the
changeover contact of the code lock.
• Enable the programming mode; see chapter 9. a).
• Enter a memory number (
• The colour of the flashing control LED indicates whether the memory is full:
- LED flashes red: Memory is already used by a transponder or a user code
- LED flashes green: Memory is empty
• If you want to cancel the tuning in process, briefly press the
• If you want to clear an occupied memory, press the
will flash green and a transponder can now be tuned in; see next step.
• To tune in a transponder, just hold it in front of the code lock.
• Once the transponder has been detected, the code lock will emit a short sound signal. Then
you will hear a long sound signal, which means that the transponder has been tuned in. The
control LED will flash yellow.
If the transponder has already been tuned in to another memory number, the code
lock will emit 3 short sound signals and the tuning in process will not be possible.
• Enter the desired user code (the code length of the user code must match that of the master
code, e.g. 4 digits).
• The code lock will emit a long sound signal and the control LED will glow yellow steadily.
If desired, you can now create another user (with transponder/user code) in a memo-
ry; start again when entering the memory number; see above.
• Press the button to exit programming mode. The control LED will glow red steadily.
..... ).
button.
button twice. Then the control LED
45