Tuning In The User Transponder - Sygonix 1717531 Bedienungsanleitung

i) Tuning in the user transponder
The code lock has 3 different operating modes; see chapter 9. c):
• Operating mode 1 = Activation of the changeover contact via the transponder
• Operating mode 2 = Activation of the changeover contact via the user code or the transponder
• Operating mode 3 = Activation of the changeover contact via the user code and the tran-
sponder
Tuning in the transponder only (for operating mode 1):
If you want to enable the changeover contact only via the transponder (operating
mode 1), the entry of a user code is redundant. Proceed as described below.
• Enable the programming mode; see chapter 9. a).
• Enter a memory number (
• The colour of the flashing control LED indicates whether the memory is full:
- LED flashes red: Memory is already used by a transponder or a user code
- LED flashes green: Memory is empty
• If you want to cancel the tuning in process, briefly press the
• If you want to clear an occupied memory, press the
will flash green and a transponder can now be tuned in; see next step.
• To tune in a transponder, just hold it in front of the code lock.
• Once the transponder has been detected, the code lock will emit a short sound signal. Then
you will hear a long sound signal, which means that the transponder has been tuned in. The
control LED will flash yellow.
If the transponder has already been tuned in to another memory number, the code
lock will emit 3 short sound signals and the tuning in process will not be possible.
• Briefly press the
another transponder, if desired. Proceed as described above when entering the memory
number.
• Press the button to exit programming mode. The control LED will glow red steadily.
44
.....
button, the control LED will glow yellow steadily. Then you can tune in
).
button.
button twice. Then the control LED