Menu Show Data; Menu Trace - IFM Electronic EC2036 Bedienungsanleitung

2.3.2. Menu Show Data

COB-ID: xxx
Length: d
D.:xx xx xx xx
xx xx xx xx
COB-ID: xxx
Length: d
D.: xx xx xx xx
The indicated data are updated every 200 ms via RTR message requests.

2.3.3. Menu Trace

F1 Trigger: AUTO
F2 RecTele: 0000
F3 _Start, *Stop
F4 Send Buffer
F1 Trigger: AUTO
F2 RecTele: 0000
F3 _Start, *Stop
F4 Send Buffer
Input of the complete CAN-ID (3 digits, hexadecimal, 11 bits)
Display of the number of the data bytes
Display of data
Display of the current trigger mode. By pressing F1 the trigger mode and the
trigger conditions can be changed (=> menu "Trigger").
By pressing F2 it is possible to look at the messages transferred via the bus.
The number of the received messages is shown right-aligned.
Since the buffer can only contain 1024 messages the first messages are
overwritten by current messages if this number is exceeded.
Starts or stops writing current messages transferred via the bus into the
buffer. If the trigger type is not set to "AUTO", starting or stopping the writing
into the buffer depends on the occurrence of the trigger condition according
to the selected trigger type. "*" before "_Start" or "_Stop" indicates the
current state "Reception" or "Reception stopped". "!" at the end of the 4th
display line (after "F4 Send Buffer") indicates that the bus transmission is
disturbed (error frames received).
Sends the contents of the buffer to the CAN bus. This is done to transfer and
further process the traced messages, e.g. to an external PC.
Seite/Page 53