Menu I/O Config - IFM Electronic EC2036 Bedienungsanleitung

Menu I/O Config.

After selection of the menu point first enter the number of the node (3 digits, decimal) for which the
new setting is to be valid.
Node-ID: ddd
After pressing ENTER the PWM frequency can be entered if the module allows this setting. The
default value is 100 (100 Hz). The setting is valid for the whole module.
In the next line the wire break and short circuit diagnosis for modules with diagnostic capabilities can
be activated and deactivated. The default setting is 0 (off). The setting is valid for the whole module.
In the lines 3 and 4 the configuration of the input/output channel can be changed. To do so, the
channel number and then the type are entered.
PWM-Frq: ddd
Diag. 0/1: d
Channel: dd
Type: dd
With pressing ENTER the new PWM frequency, the diagnostic state and the configuration of the
selected channel are transferred. If the configuration is successful, (+) is indicated in the
corresponding line.
If the configuration is not successful or the function is not valid for the connected module, (-) is
indicated.
After input of the values in line 4 and pressing ENTER the channel number is increased by 1 in the
third line. This enables a channel configuration in rising order. Only the channel type must be entered.
Pressing ESC terminates the configuration.
Seite/Page 50