Connecting The Receiver - Auerswald COMfortel 1200 Inbetriebnahmeanleitung

2.
Push the insert cautiously upward to remove it.
3.
Turn the insert.
4.
Install the insert so that the hook points upward.
5.
Tilt the insert slightly forward with your finger.
6.
Press the insert down until it clicks into place.
Important: Always press onto the insert from the top (see Fig. 12). Pres-
sure exerted onto the front of the insert may shear off the ratchets holding
the insert.
Fig. 12: Pressing down the insert
Notes regarding handling:
To hang up the receiver, use the slot on the inside of the receiver to hang it
onto the hook you have just inserted in the receiver recess.
To hang up the receiver without terminating a call, use the slot on the inside
of the receiver to hang it onto the hook at the top of the telephone.

Connecting the Receiver

1.
Insert the RJ-10 connector at the longer, plane end of the spiral cord into
the jack labelled with
page 42).
2.
Guide the cable to the outside using the corresponding cable channel.
COMfortel 1200/1400 - Firmware V1.8 - COMfortel Set V3.10.0 - Setup V02 05/2015
on the lower side of the telephone (see Fig. 13 on
Preparation
41