Connecting The Charging Cradle; Inserting The Battery And Closing The Battery Compartment Cover - Auerswald COMfortel M-530 Betriebsanleitung

Connecting the Charging Cradle

1. Connect the flat connector (A) on the end
of the wall-mounted power supply cable
(B) to the charging cradle (C).
2. Plug the wall-mounted power supply (B)
into the mains socket.
Disconnect the flat connector from the
charging cradle (C) again:
1. Disconnect the wall-mounted power
supply (B) from the mains.
2. Press the unlocking key (D).
3. Disconnect the flat connector (A).

Inserting the Battery and Closing the Battery Compartment Cover

Warning: Using unapproved rechargeable batteries or normal batteries
can cause serious harm to health or damage to equipment, and also
functional faults or damage to the device. The casing of rechargeable
batteries can be destroyed, or rechargeable batteries can explode.
1. Insert the rechargeable batteries with the
correct polarity (+/- alignment as shown
in Figure A).
2. Hold the rechargeable battery cover at a
slight angle and first slide it onto the
casing (B) from below.
3. Then press the cover to close it, until it
clicks in place (C).
4. Insert the locking disc as shown in Image
D (rotated approx. 20°). Also note the
arrow marking.
COMfortel M-530 - Instructions V02 08/2019
Initial Commissioning
A
B
C
D
A
D
B
C
D
23