Preparation
3.
Insert the other RJ-10 connector of the spiral cord into the jack on the re-
ceiver.
Connecting a Headset
Requirements
–
A wired headset corresponding to the technical data listed on page 35.
1.
Insert the headset connector:
2.
Guide the cable to the outside using the corresponding cable channel.
Fig. 14: Connecting a headset
42
COMfortel 1200/1400 - Firmware V1.8 - COMfortel Set V3.10.0 - Setup V02 05/2015
Fig. 13: Connecting the receiver
COMfortel 1200: Pull the connector of the receiver out of the socket at
the back marked with
socket instead (see Fig. 13).
COMfortel 1400: Insert the connector of the headset into the jack
labelled with
on the lower side of the telephone (see Fig. 14).
and insert the connector of the headset into this