Operating Additional Attachments For The Multi Pilot - Jungheinrich EFG 535 Betriebsanleitung

4.15 Operating additional attachments for the Multi Pilot

WARNING!
Incorrect symbols can cause accidents
Symbols on controls that do not depict the function of the attachments can cause
accidents.
Mark the controls with symbols that indicate their function.
Specify the attachments' direction of movement in accordance with ISO 3691-1 so
that they match the controls' direction of movement.
4.15.1 Multi Pilot with control of ZH1 hydraulic port
Z
Depending on the attachments used the
button (114) is assigned the function of the
attachment. Levers that are not required are
void. For connections (see "Fitting additional
attachments" on page 98).
Procedure
• Operating hydraulic port ZH1:
Press the button (114) to the left or right.
The attachment performs its operation.
4.15.2 Multi Pilot with control of ZH1 and ZH2 hydraulic ports
Z
Depending on the attachments used the lever
/ button (114,115,72) is assigned the function
of the attachment. Levers that are not required
are void. For connections (see "Fitting
additional attachments" on page 98).
Procedure
• Operating hydraulic port ZH1:
Press the button (114) to the left or right.
• Operating hydraulic port ZH2:
Push or pull the lever (115) and at the same
time press the button (72).
The attachment performs its operation.
96
114
115
114
72