Residual Risks; After Use - Black+Decker ST5528 Übersetzung Der Ursprünglichen Anweisungen

ENGLISH (Original instructions)

Residual risks

Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the relevant
safety regulations and the implementa-
tion of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotat-
u
ing/moving parts.
Injuries caused when changing any
u
parts, blades or accessories.
Injuries caused by prolonged use
u
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing
u
dust developed when using your tool
(example:- working with wood, espe-
cially oak, beech and MDF).

After use

When not in use, the appliance should
u
be stored in a dry, well ventilated place
out of reach of children.
Children should not have access to
u
stored appliances.
When the appliance is stored or trans-
u
ported in a vehicle it should be placed
in the boot or restrained to prevent
movement following sudden changes
in speed or direction.
6
Inspection and repairs
Before use, check the appliance for
u
damaged or defective parts. Check for
breakage of parts and any other condi-
tions that may affect its operation.
Do not use the appliance if any part is
u
damaged or defective.
Have any damaged or defective parts
u
repaired or replaced by an authorised
repair agent.
Never attempt to remove or replace
u
any parts other than those specified in
this manual.
Additional safety instruc-
tions for grass trimmers
Warning! Cutting elements continue
to rotate after the motor is switched off.
Be familiar with the controls and the
u
proper use of the appliance.
Before use, check the power supply
u
cord and extension cord for signs of
damage, ageing and wear. If a cord
becomes damaged during use, discon-
nect the cord from the mains supply
immediately. DO NOT TOUCH THE
CORD BEFORE DISCONNECTING
THE SUPPLY.
Do not use the appliance if the cords
u
are damaged or worn.
Wear stout shoes or boots to protect
u
your feet.
Wear long trousers to protect your
u
legs.
Before using the appliance, check that
u
your cutting path is free from sticks,
stones, wire and any other obstacles.
Only use the appliance in the upright
u
position, with the cutting line near the
ground. Never switch the appliance on
in any other position.
Move slowly when using the appliance.
u
Be aware that freshly cut grass is
damp and slippery.
Do not work on steep slopes. Work
u
across the face of slopes, not up and
down.
Never cross gravel paths or roads
u
while the appliance is running.
Never touch the cutting line while the
u
appliance is running.
Do not put the appliance down until the
u
cutting line has come to a complete
standstill.
Use only the appropriate type of cut-
u
ting line. Never use metal cutting line
or fishing line.
Be careful not to touch the line trim-
u
ming blade.
Take care to keep the mains cable
u
away from the cutting line. Always be
aware of the position of the cable.
Keep hands and feet away from the
u
cutting line at all times, especially
when switching on the motor.
Before using the appliance and after
u
any impact, check for signs of wear or
damage and repair as necessary.
Never operate the appliance with
u
damaged guards or without guards in
place.
Take care against injury from any
u
device fitted for trimming the filament
line length. After extending new cutter
(Original instructions) ENGLISH
line always return the machine to its
normal operating position before
switching on.
Always ensure that the ventilation slots
u
are kept clear of debris.
Do not use the lawn trimmer (edge
u
trimmer), if the cords are damaged or
worn.
Keep extension cords away from cut-
u
ting elements.
Electrical safety
#
This appliance is double insu-
lated; therefore no earth wire is
required. Always check that the
power supply corresponds to the
voltage on the rating plate.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved
u
by using a highsensitivity 30 mA Re-
sidual Current Device (RCD).
Labels on appliance
The following warning symbols are found on the appliance
along with the date code:
Read the manual prior to operation.
Wear safety glasses or goggles when operating
N
this appliance.
Wear suitable ear protectors when operating this
appliance.
E
Always remove the plug from the socket before
inspecting a damaged cable. Be careful not to
use your strimmer if the cable is damaged.
7