Battery; Removal - Beta Motorcycles ALP 200 Bedienungsanleitung

4
1
EN

BATTERY

Battery is located under the saddle and
requires no maintenance.
Keep the battery terminals clean. If neces-
sary, protect them with a thin film of acid-
free grease.

REMOVAL

Remove the saddle, the tank cover and the
2
undersaddle plastic shield, as described
in "Body disassembly and reassembly" on
page 62 .
Remove the cover 1 by loosening the
screw 2.
Release rubber band.
FIRST disconnect the negative connector
(black) from negative (-) pole and THEN
positive connector (black) from negative
(+) pole.
Remove the battery.
When fitting the battery, insert it with the
terminals as shown in picture.
FIRST connect the positive connector (red)
from positive (+) pole and then negative
connector (black) from negative (-) pole.
WARNING:
Exercise extreme caution if, for any
reason, the electrolyte (sulphuric
acid) should come out of the battery.
The electrolyte can cause serious
burns. In case of contact with the
skin, rinse abundantly with water.
54