3.1 PRELIMINARY INFORMATION
General
Operate in compliance with safety regulations in force.
For detailed information (dimensions, weight, technical
characteristics etc.) please refer to the TECHNICAL
INFORMATION section.
Use single protection devices : gloves, glasses ecc.
During positioning consider these elements :
•
technical spaces required for the machine and system
•
place where the machine will be installed
•
electrical connections
•
water connections
•
air / aeraulic ducts
Do not considerer these elements could decrease
performances and operational life of the unit.
3.2 FUNCTIONAL SPACES
Functional spaces are designed to:
•
guarantee good unit operation
•
Carry out maintenance operations
•
protect authorized operators and exposed people.
Respect all functional spaces indicated in the figure.
3 - POSITIONING
3.3 POSITIONING
Avoid installing the unit in proximity to:
•
positions subject to exposure to direct sunlight;
•
in proximity to sources of heat;
•
in damp areas or places with probable contact with water;
•
in places with oil fumes
•
places subject to high frequencies.
Make sure that :
•
the wall on which the unit is to be installed is strong
enough to support the weight;
•
the part of the wall interested does not have pipes or
electric wires passing through;
•
the interested wall is perfectly flat;
•
there is an area free of obstacles which could interfere
with the inlet and outlet air flow;
•
the installation wall is preferably an outside perimeter wall
to allow the discharge of the condensation outside;
•
in case of ceiling installation the airflow is not directed
towards persons.
If provided a wall-mounted ambient thermostat - OPTION - :
Install the room thermostat far from heat sources (radiators,
sunbeam, kitchens), from doors , windows etc.
OK
1,5 m
52