CLIVET ELFORoom2 3 Anleitung Zur Installation Und Wartung Seite 71

mode
Fan speed adjustment
off
Pressing the mode/off button changes the fan speed between
supersilent, minimum, medium and maximum.
When the function is activated, the relative symbol on the
display turns on.
The supersilent speed will lead to strong dehumidification in
cooling and to radiant operation only (with fan off and solenoid
on) in heating.
By setting the top speed, one immediately obtains the
maximum deliverable power both in heating and cooling
mode.
Once the desired ambient temperature has been reached, we
recommend selecting one of the other 3 operating modes to
achieve greater thermal and acoustic comfort.
6 - CONTROL
Ambient temperature probe failure (AIR).
6 flashing LEDs (alarm with automatic reset).
Failure affecting the water temperature probe (H2) located in the main coil. 2 flashing LEDs (can be
reset manually).
If the board detects the water temperature probe fitted on the appliance, start-up takes place in
normal conditions. If the probe is not connected, it is possible to confirm operation without the probe
by pressing the Heating/Cooling key for 5 seconds.
Problem affecting the fan motor (for instance a jam due to foreign bodies, a rotation sensor failure,
the activation of the grille protection micro switch due to the cleaning of the filter). 4 LEDs flashing all
together (alarm with automatic reset).
(Hot or cold) water request not met (above 20°C in cooling mode, below 30°C in heating mode).
The LED of the selected function flashes and the fan is stopped until the water temperature reaches
a value that is suitable to meet the request.
Keys lock
By pressing the increase and decrease temperature together
for 5 seconds, the local block of all the keys is activated. This
is confirmed by the fact that the word bL is shown on the
display.
The user is prevented from using all the adjustments and
pressing any key and the display shows bL.
The keys are unlocked by repeating the sequence.
Temperature change set
Use the two buttons to set the desired room temperature
which is displayed on the 2 digit display.
The adjustment range is from 15 to 30 °C, with resolution is 1
°C, but are also permitted off-scale values of 5 °C and 40 °C.
Only set these values for short periods and then set the
selection to an intermediate value.
The command is very precise, set it to the desired value and
wait until the command has made the adjustment based on
the room temperature detected.
Alarms
71