Filling The System - CLIVET ELFORoom2 3 Anleitung Zur Installation Und Wartung

4.5 MOUNTING FRONT GRILL SAFETY SUPPORT
In the case in which the coolerconvector is installed in a
horizontal position, to guarantee the safety of the cleaning/
filter replacement operations it is obligatory that the two
clamps, in the supplied bag together with the instruction
manual and the accessories, are mounted by the installer.
•
Separate the two clamps (fig. 4.8 rif. A);
fig 4.8

4.6 FILLING THE SYSTEM

When starting up the system, make sure that the hydraulic
unit lockshield is open. If there is no electric power and the
thermo-valve has already been powered use the special cap
to press the valve stopper to open it.
•
Open all the system interception devices (manual or
automatic);
•
Start the filling by slowly opening the system water filling
tap;
•
For the models installed in a vertical position, take a
screwdriver and act on the highest breather of the battery
(fig.4.9 rif.A);
fig 4.9
4 - WATER CONNECTIONS
•
•
•
•
•
•
•
•
open the front grill and completely unscrew the fixing
screws on the springs (fig. 4.8 rif. B);
fix the two clamps, blocking them by retightening the screws
(fig. 4.8 rif. B);
fix the other part of the clamp to the grill using the supplied
screws (fig. 4.8 rif. C);
Close the grill.
for appliances installed in a horizontal position, act on the
highest positioned breather (fig.4.9 rif.B);
When water starts coming out of the breather valves of the
appliance, close them and continue filling until reaching the
nominal value for the system.
Check the hydraulic seal of the gaskets.
It is advisable to repeat these operations after the appliance
has been running for a few hours and periodically check the
pressure of the system.
59