Operating The Cpg500 Digital Pressure Gauge; Turning On (On); Turn Off (Off); Turn On Backlight - WIKA CPG500 Betriebsanleitung

6 Commissioning, operation
6.2

Operating the CPG500 digital pressure gauge

6.2.1 Turning on (ON)

6.2.2 Turn off (OFF)

Press once (briefly)

6.2.3 Turn on backlight

Press for 2 seconds. The backlight is shut off automatically after 20 seconds.

6.2.4 MIN/MAX indication

Use this key to toggle the required value.
The key function is sequential; the values are indicated in the display in sequence.
The MIN/MAX function is used to measure pressure peaks. The respective lowest (MIN) and
highest (MAX) measured values are stored in the MIN/MAX memory. Values in the MIN/MAX
memory are erased when the device is turned off. If different pressure tests are to be carried out in
succession, the MIN/MAX memory must be erased after each measurement.
MIN/MAX-value is indicated in the display.
WIKA Operating Instruction, Model CPG500
A self-test procedure is carried out
The measuring range is indicated (FS)
Auto Power Off function is active.
Power off activates automatically after
5 minutes. This function can be
altered in MENU.
Display mode:
ACT value displayed
GB
13