H) Switching Over Reading Display For Outdoor Sensors; I) Searching Outdoor Sensor - Conrad Electronic LumiNight Bedienungsanleitung

i) Searching outdoor sensor

If the battery is changed on the outdoor sensor, or a channel is changed or if the reception
conditions are difficult, it may happen, that only lines ("- -") are shown on the display area for the
readings

It is possible that the base station is receiving the radio transmission data of your
neighbour's sensors. This can lead to reception problems of your own outdoor
sensor. If this is the case, change the transmission channel on the outdoor
sensor and reregister it.
If the temperature or air humidity ranges are above or below (see "Technical
Specifications") there will also be lines shown on the display again.
This is why you can start the search for an outdoor sensor manually.
• Insert the batteries in the outdoor sensor as described in chapter 9. b) (or press the "RESET"
key (18) in the battery compartment of the outdoor sensor) and set a channel (1 to 5) with
the "CH" key (16) within the next 10 seconds. A channel number must only be assigned once.
• Select the set sensor number by pressing the key with the outdoor sensor icon
several times.

If a rotating arrow icon (H) is shown under the number, this means that the base
station is searching all 5 channels.
• Start the sensor search by pressing the key with the outdoor sensor icon
two seconds. A brief sound can be heard and the reception icon flashes above the sensor
number (G).

Since the outdoor sensor only emits readings about every minute it may take a
little until there is a display on the base station.
• The sensor search of the base station takes about 2 minutes.
In order to stop it prematurely, simply press the key with the outdoor sensor icon
for more than 2 seconds until a signal can be heard. The reception icon stops flashing.
.
74
(4) briefly
(4) for about
(4) again