D) Battery Compartment On The Back Of The Base Station - Conrad Electronic LumiNight Bedienungsanleitung

d) Battery compartment on the back of the base station

10 Socket for external power supply
This is where you connect the external power supply unit included in delivery. The cable
can be guided towards the bottom through a cable channel.
11 Battery compartment
Insert four type mignon/AA batteries with correct polarity.
The polarity for plus/+ and minus/- is marked on the battery compartment.
12 "MODE" sliding switch
The switch is for the selection of the function for the background lighting of the LC display:
• AUTO: The background lighting is activated automatically for approx. 5 seconds, eg
when the key is pressed or when the IR sensor detects a movement.
• OFF: The background lighting is only activated for 5 seconds when a key is pressed
• ON When the plug-in power supply included in delivery is connected, the illumination
is turned on permanently. In the case of a power cut (or when the plug-in power supply
is disconnected), is the function the same as with "AUTO".
13 "°C/°F" key
• Short keystroke: The temperature display is switched between °C (degrees Celsius)
and °F (degrees Fahrenheit).
14 "RESET" key
• Short keystroke (for reasons of safety, the key is counter-sunk, to actuate it, use, eg
a toothpick): The base station is reset to factory default. Alternatively you can briefly
remove the batteries.
57