Getting Started; A) Getting Started With Base Station - Conrad Electronic LumiNight Bedienungsanleitung

9. Getting Started

Please note this important information:
First of all insert the batteries in the base station only then insert them in
the outdoor sensors (if there are more than one).
Settings on the base station can only be carried out when the sensor
search of the base station (approx. 2 minutes) was completed and
afterwards the search for the DCF time signal (approx. 10 minutes).
If you want to try the product out when you first use it, eg in a room, you should not place the
individual devices (base station, outdoor sensor) directly next to each other.
Otherwise there may be reception problems due to radio interferences. Keep a distance of at
least 1m between the individual devices.
a) Getting started with the base station
• Open the battery compartment on the back of the base station, slide the battery compartment
lid down and take it off.
• Insert four AA batteries with correct polarity into the battery compartment (11) of the base
station (observe plus/+ and minus/-). There is a corresponding illustration in the battery
compartment.
• After inserting the batteries all available display elements will appear for a couple of seconds,
as you can see on the fold-out page.
• If so desired, you can connect the power supply included in delivery to the socket (10)
(necessary for continuous illumination).
• Close the battery compartment again.
• The outdoor temperature display shows "—.-", on the left above the sensor number (G) the
reception display flashes (the base station is now searching for available outdoor sensors).

The search mode is now active for approx. 2 minutes. Insert the batteries in the
outdoor sensor(s), as described below in chapter 9. b)
During this time no other settings are possible. Wait until the reception display
above the sensor number (G) stops flashing.
59