Setting Of Clock/Date - Conrad Electronic LumiNight Bedienungsanleitung

12. Setting of Clock/Date

As already described in chapter 11, it may be necessary to set the time and date manually if the
DCF reception is bad.
For the manual setting as well as for the DCF reception the 12/24 hour display, the sequence
of day and month on the display and the language for the display of the abbreviation of the
weekday can be selected.

If the DCF reception is active, simply skip the setting of the time and date (don't
change anything). Below, you will find out how to do this.
The setting is carried out in the following steps:
• You have to be in the normal time display mode (no alarm display). If necessary press the
time key (1) several times, until the time is displayed.
• Press the time key
mode (12 or 24 hours) flashes on the display ("12h" or "24h").
• Adjust the mode with the " " or " " key.

If no key is pressed for 10 seconds the current setting is copied and the setting
mode is exited. The current time is displayed again.
• By briefly pressing the time key
• The hour display flashes.

Please note: If the DCF reception was active beforehand, it is switched off when
the time is adjusted!
• Set the hours with the " " or " " keys, if so desired. If the respective key is pressed for a
longer period of time, quick adjustment is performed.

If no key is pressed for 10 seconds the current setting is copied and the setting
mode is exited. The set time is displayed.
• By briefly pressing the time key
• The minute display flashes.

Please note: If the DCF reception was active beforehand, it is switchd off when
the time is adjusted!
64
(1) for about 2 seconds until a tone signal can be heard. The current
(1) you will change to the next setting step.
(1) you will change to the next setting step.