E) Selecting Unit For Air Pressure Display - Conrad Electronic LumiNight Bedienungsanleitung


The air pressure readings which you get from, eg the radio or Internet, are
always converted to sea level. For the weather station to accept this conversion,
the altitude on the installation site has to be entered.
For this purpose, proceed as follows:
• You have to be in normal operating mode, on the bottom of the display the time is shown,
in the middle of the display the reading for the air pressure is shown.
• Press the file folder icon
• "0" will appear on the display and behind it the flashing altitude unit "meter" (or "foot"). By
briefly pressing the "UNIT" (6) key, the unit can be selected.

If no key is pressed for about 10 seconds, the setting mode is exited and the
present setting is copied.
• Confirm the setting by briefly pressing the file folder icon
• The current altitude will flash on the display (in delivery state "0").
• The altitude can be adjusted with the "UNIT" key (6). Hold the key down for a longer period
of time, to activate the fast adjustment.
0 If no key is pressed for about 10 seconds, the setting mode is exited and the
present setting is copied.
• Confirm the setting by briefly pressing the file folder icon
• The display shown will change back to the normal presentation of the air pressure.

e) Selecting unit for air pressure display

• You have to be in normal operating mode, on the bottom of the display the time is shown,
in the middle of the display the reading for the air pressure is shown.
• Briefly press the "UNIT" (6) key, the units for the air pressure display changes between "InHg"
and "mb/hPa".
72
(3) on the front of the weather station for two seconds.
(3) key.
(3) key.