Inhaltsverzeichnis
Werbung
l) Alarm time setting
• Briefly press the "
" button once to display the alarm time.
• To set the alarm time, press and hold the "
The hour digits of the alarm time start flashing.
• By pressing the " " or " " buttons the hours can be set.
A quick setting can be done holding down the " " or " " buttons
for an extended period of time.
If you do not press any button for a minute, the last setting will be
stored and the alarm time setting mode will automatically be exited.
• Briefly press the "
" button. The minute digits of the alarm time start
flashing.
• Pressing the " " or " " buttons will set the desired minutes.
• Briefly press the "
" button. The pre-set alarm time will be stored and the
unit returns to the normal clock display.
m) Switching alarm on/off
To switch the alarm on/off, press the "ALARM ON/OFF" button on the back of
the base unit.
If the alarm has been activated, a small bell icon is
displayed on the bottom display line, see figure to the
right.
After the alarm has been switched off, the bell icon will
disappear.
60
" button for about 3 seconds.
6. System description
The base unit has a large LC display which allows you to view indoor
temperature, indoor humidity, time/date and the outdoor temperature
measured and transmitted by the remote sensor. The base unit supports up to
three remote sensors (one included).
A built-in barometer (changes in barometric pressure can be used to forecast
the weather with relative accuracy) enables the unit to display the weather
forecast in the form of graphical icons ("Sun", "Clouds", "Rain").
You do not need to install any wires due to radio transmission from remote
sensor to base unit (433 MHz technology) which simplifies the installation and
offers you additional options. You can install, as an example, one remote
sensor in the carport, the other one in the heating room and the third one can
measure and transmit the temperature from your storage room.
The base unit can store the maximum/minimum readings of the outdoor/indoor
temperature and of the indoor humidity measured by the remote and indoor
sensor.
In addition, there is a trend indicator, integrated into the LC display to show the
temperatures measured by the remote sensor as well as a comfort level
indicator for the indoor humidity (in the form of "Smilies").
The current time and date will automatically be synchronized by DCF radio
signals, when the base unit is within a maximum radius of approx. 1500 km
from Frankfurt on the Main, Germany (DCF77), where the signals are
generated.
You can also set the time and date manually when not within the range of the
DCF transmitter.
The weekday display is available in 5 languages: English, German, Spanish,
French, Italian.
The base unit features a switchable on/off alarm time function.
The base unit can be wall-mounted (there is a mounting hole on the rear of the
unit) or placed on a flat surface by means of the included table stand.
41
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
