N) Reset - Conrad Electronic LumiNight Bedienungsanleitung

• Briefly pressing the "MODE" key (7) changes to the setting of the display colour at night.
• By briefly pressing the "UNIT" (6) key, it can be switched between the following settings:
"A" flashes on the display:
Automatic change between normal and inverse display at night.
"B" flashes on the display:
Inverse display (during the day and at night)
"W" flashes on the display:
Normal display (cannot be read at night, as with any other LC display)

The background lighting of the display switches itself on, depending on the
setting of the slide switch BACKLIGHT" (12), eg via an integrated sensor.
If the setting is "W" as described above and if the "BACKLIGHT" switch is in the
"OFF" position, then there is no possibility to read the display at night.
• By briefly pressing the "UNIT" (6) key, the setting mode can be exited.

If no key is pressed for about 10 seconds, the setting is copied and the setting
mode is also exited.

n) Reset

Briefly pressing the "RESET" key (14) on the inside of the battery compartment resets the base
station, eg if there is only a faulty readout on the display after having inserted the batteries.

Doing this, all saved data gets lost.
Alternatively, you can take out the batteries from the base station and insert them again.
77