K) Ending The Drive; L) Carrying The Vehicle - Reely Rock Crawler Bedienungsanleitung

k) Stopping the drive
To stop the drive, proceed as follows:
• Let the vehicle roll to a halt.
• Once the vehicle is stationary, remove the car body and switch off the vehicle (switch position "0").
• Disconnect the drive battery from the cruise control. Remove the plug-in connection completely.
• Now you may turn off the transmitter.
Attention!
The motor, drive control unit and rechargeable battery pack can become very hot during operation! Therefore,
do not touch these parts immediately after driving. Danger of burns!
Stop driving straight away when you notice unusual responses of the vehicle to the control commands on
the transmitter or when the vehicle no longer responds.
This behaviour could be caused by a weak vehicle battery, weak batteries/rechargeable batteries in the
transmitter or by an excess distance between the vehicle and the transmitter.
An antenna which is not fully extended, disturbances on the radio channel used (e.g. other models, radio
transmissions through other devices) or adverse transmission/reception conditions could also be a cause
for unusual responses of the vehicle.

l) Carrying the vehicle

Radio interferences, accidental operation of the transmitter or another transmitter on the same channel may lead to
unexpected reactions of the vehicle.
Therefore you have to make sure that you do not reach into the drive when putting the vehicle into its start
position or picking it up from the floor.
35