B) Mounting The Wing Dowels - Reely SKY Air Lady Bedienungsanleitung

b) Mounting the wing dowels

• The heat shrink film in the area of the fuselage bores (1) is removed with a balsa knife.
Our tip:
With a small soldering gun, which is inserted from the outside through the borings, the edges of the foil
can be soldered flush with the edge of the hole.
• Then, the wing dowels (2) are inserted through the bores and aligned. The ends projecting at the right and the left
should be of the same length.
• A thin fluid super glue or PVAC glue is suitable to glue the wing dowels.
40
Figure 3