Reset To Factory Settings; J) Programming The Timers Of The Receivers - Conrad FS20 SN Bedienungsanleitung

i) Reset to factory settings
1 2
hold down for 5 seconds
Status LED D1 flashes
2
1
Status LED D1 goes out
Caution:
When factory settings are restored, a new house code is generated, so you
either have to re-assign all receivers or assign the old house code in FS20 SN.

j) Programming the timers of the receivers

If you intend the use a receiver controlled by FS20 SN with additional transmitters (remote
controls) in connection with the integrated timer, you can programme the internal timer of the
receiver as follows:
• Hold down the assigned pair of buttons shortly (longer than 1 second but less than 5
seconds) simultaneously. This starts and stops timing. During timing, the LED of the receiver
flashes.
• Observe the operating instructions of the receiver
• The on-time settings described in chapter 11. g) have priority over the internal timer setting
of the receiver if a transmission signal between 33 and 43 has been set as described in
chapter 11. h).
• To use the internal timer of the receiver with FS20 SN, the transmission command must be
between 11 and 32.
3 4
4
3
Press any button
• Hold down buttons 2 and 4 simultaneously for
about 5 seconds until status LED D1 flashes.
• Press any button.
If you do not wish to restore factory settings,
do not press a button for at least one minute.
• Status LED D1 goes out and factory settings
(see chapter 7. b) are restored.
55