Resetting To Factory Settings; Handling - Conrad FS20 RSU Bedienungsanleitung

10. Resetting to Factory Settings

If required, you can delete any programming changes saved in the control unit at once.
• Press the 'retract' button connected to the "FS20 RSU" for at least 5 seconds.
• As soon as the roller shutter is rolled out, the programming mode is active for 1 minute.
• Briefly press one of the control buttons. Now all of the assigned addresses are deleted and
the timer is set back to 1 minute.

The "FS20 RSU" now does not react to any remote control commands and must
be reprogrammed.

11. Handling

Caution, danger!
Only people with an appropriate training are entitled to carry out work on
voltage-carrying parts. If you have not had such training, consult a qualified
electrician for such work.
Make sure that the insulation of the entire product is intact and not damaged. Never
disassemble the product.
Generally the "FS20 RSU" is installed once and remains permanently mounted at the same
location. Check the fitness of the product occasionally correspondingly to the mounting
location.
The following unfavourable conditions are to be avoided at the place of installation or during
transport:
- dampness or high humidity
- extremely cold or hot temperatures
- dust or flammable gases, fumes or solvents
- strong vibrations
- strong magnetic fields such as those found in the vicinity of machinery or loudspeakers
25