E) Function "Time/Date" (Symbol; Switching The Display Data; Setting The Language For The Weekday, Geographic Position, Date And Time - Conrad TE831X Bedienungsanleitung

e) Function "Time/Date" (Symbol "


In the basic display mode of the weather station, select the function "Time/date" with the button " "
(6) or " " (7). The corresponding symbol (see above) blinks.
The following setting options and displays are available now:
 Switching the display data
Briefly press the button "SET" (5) repeatedly to switch between the following displays:
• Time (Hour : Minute : Seconds)
• Date (Day : Month : Year, or Month : Day : Year, depending on the setting)
• Time UTC (Hour : Minute)
• Time and weekday (Hour : Minute : Weekday)
• Time and city (Hour : Minute : City)
 Setting the language for the weekday, geographic position, date and time
The following settings need a bit of time. It is important that you previously select a city in the appendix, which is close
to your place of residence. This geographical data is later on used to calculate the sunrise and sunset times.

As a special feature of the weather station, "professionals" can also enter the geographic degrees of
longitude and latitude (minute and degree of arc); this data is available in the Internet or on special
maps.
The setting takes place in a specific sequence, which must be performed completely (step 1 to 13).
If you keep the button "SET" (5) depressed for longer, you leave setup mode and all changes/settings already
performed are lost in the process! The same applies if you do not make an entry for some time.
Step 1:
Keep the button "SET" depressed until the language for the display of the weekday appears next to the time. Set
the desired language with the button " " (6) or " " (7):
GER = German
ENG = English
DUT = Dutch
SPA = Spanish
ITA = Italian
FRE = French
Step 2:
Briefly press the "SET" button (5) to access the next setting.
Step 3:
The display shows "CITY" and the three-digit city code blinks (or the abbreviation for a city). The city codes are listed
in the appendix to these operating instructions. Set the desired city code with the button " " (6) or " " (7):

You should select a city in your proximity so that the internal calculation for the sunrise and sunset times
is as accurate as possible.
When selecting "USR" as city code, you can enter the exact geographic location of your region using
the degrees longitude and latitude, if this data is available (e.g. in the Internet or similar), see point 4.
78
")