Operating The Weather Station, Basic Functions; A) Performing A Dcf Reception Test; B) Searching For Sensors; Background Illumination - Conrad TE831X Bedienungsanleitung

11. Operating the weather station, basic functions

a) Performing a DCF reception test

If the weather station has not detected a DCF signal, you can also start a manual reception attempt for the DCF signal.
To do so, keep the button " " (7) depressed until the DCF radio tower symbol starts to blink (see chapter 9. d).
Check whether the radio tower icon indicates a good reception and wait some minutes until the right time is displayed.
Otherwise select a better location for the weather station and start the reception attempt again.

b) Searching for sensors

If only lines appear in a display field (e.g. for the rain sensor: "- - - . -"), you can start a manual search for all outdoor
sensors.
For this purpose, keep the button " " (6) depressed until the symbol for the radio reception of the outdoor sensors
blinks on the top of the display.
The sensor search may take a few minutes.
If one of the sensors is not found, check its batteries, place the sensor in a different location and reduce the distance
between the weather station and the sensor.
c) Background illumination
When using the provided power pack unit, the background illumination can be activated permanently (or it is activated
automatically at darkness and deactivated during the day).

With battery operation, the background illumination can only be activated briefly to save energy and
battery power.
You can select the desired function with the switch "LIGHT SENSOR" (13):
ON The background illumination is always on (only when using the provided power pack unit).
OFF The background illumination is off and only activated for a few seconds when briefly pressing the button
"SNOOZE • LIGHT".
AUTO The background illumination is activated at darkness and deactivated during the day.
You can select the sensitivity for the brightness detection with the switch "SENSITIVITY" (14).
66