Manual Settings - Conrad WS-9720-IT Bedienungsanleitung

• If the weather station is taken to a place that is markedly higher or lower than the original
site (e.g. from the ground level to the upstairs area of a house) than the weather station may
detect this as a change in weather.
• On the right, next to the weather symbols, you can see an arrow (5) which is used as trend
display for the air pressure:
increasing air pressure, weather improvement
falling air pressure, worsening of the weather
Once the weather trend display has registered a change of the air pressure, it will remain
permanently visible on the LC display.
e) Manual settings
The following settings can be carried out consecutively:
• Select contrast for LC display
• Time zones
• DCF time reception on/off
• 12/24h display format
• Manual time setting
• Manual calendar setting
• Switching display of temperature °C/ °F
• Select switch sensitivity for weather forecast symbols
To operate the setting menu, proceed as follows:
Briefly press the "SET" button (assuming normal display, the time is shown on the top and on
the bottom the outside temperature and air humidity is shown).
To change the displayed value, press the "+" button. A quick setting (e.g. when setting the time)
is possible by pressing the "+" for longer.
To skip a setting simply press the "SET" button again.
To exit the setting mode, briefly press the "CH" button. If you do not press any button for several
seconds, the setting mode is automatically exited.
57