Other Functions And Settings; A) Subsequent Registration Of New Sensors; Resetting To Factory Settings - Conrad WS55 Bedienungsanleitung

12. Other functions and settings

a) Subsequent registration of new sensors

New sensors can be integrated into the system at any time. Take note that there is a limit of
9 radio sensors (including combi sensor) and avoid double addressing.
• The automatic registration of new sensors is effected 2x daily (interval 12 hours) during an
automatic sensor search.
• The manual registration of new sensors can be effected at any time in connection with a
new startup of the base station. Thereby you must take note that the device will go back to
the default settings and that all saved data will get lost.
b) Resetting to factory settings
The device is delivered with the following settings:
Display A: Pool sensor or another sensor with address 8
Display B: Indoor sensor
No alarm threshold value is set
Comfort range display A: +25°C to +28°C
Warning signal is switched off
To go back to the default settings, proceed as follows:
• Open the battery compartment, remove the batteries from the device and insert the
batteries again observing correct polarity.
• All user settings will be reset to factory settings.
• All data specific to stored Min-Max values will be deleted.
• The device re-starts as described in chapter 8.
54