B) Use Of More Than One Outdoor Sensor - Conrad WS-9720-IT Bedienungsanleitung

It the readings for the outdoor temperature/air humidity are not shown within 2-3 minutes
in the lower part of the display of the weather station, take out the batteries, wait a minute
until all display segments have disappeared and start again as described above in step 1.
4. If the readings of the outdoor sensor are received correctly and displayed on the weather
station the reception of the DCF signal will start automatically (DCF reception symbol (2)
flashes).
If the reception conditions are good, this usually takes between 3 and 5 minutes. Afterwards
the time is displayed on the top on the display.
Note chapter 10 for the DCF reception.

b) Use of more than one outdoor sensor

1. If the original setting was carried out with only one outdoor sensor, than you have to first
of all remove all batteries from the weather station the existing outdoor sensor.
Wait at least one minute until all display segments have disappeared.
2. Place the batteries in the first outdoor sensor, (see also chapter 9.a).
3. Insert the batteries in the weather station within 30 minutes of powering up the first outdoor
sensor (see chapter 9.a). All display segments of the weather station are briefly visible,
afterwards the time will appear as "0:00" and the "weather girl" is shown.
Now the weather station will start to try to get reception for the outdoor sensor, the radio
symbol for the outdoor sensor is flashing.
4. After a short while the temperature/air humidity readings of the first outdoor sensor and the
radio reception symbol (6) should be displayed, continue with step 5.
If there is no display of the temperature/air humidity of the first outdoor sensor, go back to
step 1.
Keep a minimum distance of at least 50cm between outdoor sensors and the weather
station and at least 1m distance to electric/electronic devices and metal parts.
5. Insert the battery in the second outdoor sensor within 10 seconds after the readings of the
first sensor have appeared on the display of the weather station. Otherwise the weather
station will leave the mode for sensor registration.
6. Straight after inserting the battery in the second outdoor sensor (within 10 seconds), insert
the battery in the third outdoor sensor, if there is one.
7. If the readings for the second and later for the third outdoor sensor are not shown, go back
to step 1.
49