SRAM Juicy Three Installationsanleitung Seite 5

English
6
alIGn and True CalIPerS
Squeeze the front lever 5 or 6 times, then hold. Compress the lever (with your hand
or a rubber band), then snug the CPS bolts enough to hold the caliper in place.
Spin the wheel and check for rotor drag. If there is drag, loosen the
CPS bolts and repeat. Once there is no drag, torque the CPS
bolts in an alternating fashion to the specified torque.
Repeat the procedure for the rear brake.
7
adJuST reaCh
Use a 2mm hex wrench to adjust the reach if necessary.
One click equals 1mm of adjustment.
If using twist-shifters, it will be necessary to slide the levers away from
the shifters or remove them completely to access the reach adjustment
screw. Re-torque the lever clamp bolts as noted in step 5 after
adjusting the lever reach.
8
Juicy™ Three & Five Installation & Setup Guide
TORQUE TO:
8-10 Nm
(70-90 in-lb)
(in an alternating fashion)
One "click" of the
2mm hex reach
adjust screw here...
...equals 1mm of
adjustment here
95-5013-109-000, Rev. A
Juicy™ Three & Five Installation & Setup Guide
Pad rePlaCemenT
1. PuSh The PISTonS BaCk In
As the Juicy calipers are self-adjusting, the pistons need to be pushed back into the
body to their original position before the new pads can be installed. The safest way to
do this is with the old pads still in the caliper to protect the pistons. Place a flat-blade
screwdriver between the old pads, then carefully rock it back and forth, pushing the
pistons back into their bores.
2. remove The old PadS
Grab one of the pad tabs and slide the pad toward the center of the caliper (this
disengages the pad backing plate from the post in the center of the piston), then
pull the pad straight out. Repeat for the other pad. Note: The spreader clip that
sits in between the pads may not come out with the second pad. If not, push
it out from the open top of the caliper with your little finger.
3. InSTall The new PadS and SPreader
Be sure the spreader clip is oriented to the pads as shown
below. Squeeze the pad and clip assembly together, then
insert into the caliper as a unit. Firmly push until the
assembly "clicks" into place.
ChanGInG hoSe lenGThS and BleedInG
Juicy brakes come with hoses already attached in an "average" length. The system has already been bled, so if you do not
need to change the hose length, then you are ready to ride. If, however, you do need to change hose lengths, then follow
the simple procedure outlined next in this manual.
© SRAM Corporation • May 2006
English
9