SRAM Juicy Three Installationsanleitung Seite 2

Juicy™ Three & Five Installation & Setup Guide
ConGraTulaTIonS!
You have selected the best hydraulic disc brakes your money can buy! This manual contains important information for installing
and setting up and adjusting your new brakes. To ensure that your Avid Juicy brakes perform properly, we recommend that you
have them installed by a qualified bicycle mechanic. We also urge you to follow all of our recommendations to help make your
riding experience safe, enjoyable and trouble free.
First, here is some information to get you started:
TrI-alIGn™ CalIPer PoSITIonInG SySTem™
Avid disc brakes use a unique alignment system called Tri-align Caliper
Positioning System (CPS). These stacks of concave and convex washers allow
the caliper to be perfectly aligned with the rotor, regardless of imperfections in the
mounting tabs on the fork or frame, giving you full, square pad contact.
Pad Break-In
It may take anywhere from 20 to 40 complete stops to break in Avid pads. You
may begin to notice an increase in braking power after the first ride. Brake noise
can occur not only during the break-in period but off and on throughout the life
of the brake pads. Noise is dependent upon factors such as brake setup, rider
weight, riding style, braking style, and riding conditions (i.e. dust, soil, moisture,
and contamination of friction surfaces).
ChanGInG hoSe lenGThS & BleedInG
Changing hose lengths and bleeding Juicy disc brakes requires the Avid Juicy Bleed Kit
(refer to the hose and bleed section on page 11.) Please contact your local bike shop or
www.avidbike.com for details.
ToolS needed
• 2, 4 and 5mm hex wrenches
• T-25 TORX® wrench
• 10mm open-end wrench
• Adjustable torque wrench: 2.8-10Nm (25-90 in-lb) range
• Safety glasses
make Sure you have The rIGhT BraCkeTS
© SRAM Corporation • May 2006
English
CPS
hardware
CPS Bolt
Brackets
rear Front
3