SRAM Juicy Three Installationsanleitung Seite 4

English
3
mounT rear CalIPer
Loosen the CPS bolts, then mount the rear caliper (longer hose) to the I.S. tabs
on the rear of the bike. Tighten the mounting bolts to the specified torque.
Check that the caliper moves freely on the CPS hardware.
4
adJuST hoSe anGle, Then rouTe
If necessary, slightly loosen the banjo bolts on the calipers with an
8mm open-end wrench and rotate the fittings for optimal routing.
Re-tighten the banjo bolts to the specified torque, then route the
hoses. Make sure there is enough hose at critical points to allow for
suspension movement, but also make sure there aren't any big loops
of extra hose. Now, secure the hoses to the frame and fork.
Note: If you need to shorten the hose, please refer to the
"Hose Length Adjustment" section of this guide (page 11).
6
Juicy™ Three & Five Installation & Setup Guide
Loosen before
mounting
TORQUE TO:
5-7 Nm (40-60 in-lb)
If necessary, loosen
slightly and rotate for
good routing
(For Juicy five only)
RE-TORQUE TO:
5.5-6.2 Nm
(50-55 in-lb)
95-5013-109-000, Rev. A
Juicy™ Installation & Setup Guide
5
mounT leverS: Juicy Five
Mount the levers onto the handlebar in the proper position.
Arrows must point up. Make sure there is enough hose for
the handlebar to turn freely side to side. Tighten the
top bolt completely to the specified torque so there
is no gap. Tighten the bottom bolt to the same torque.
Mount levers with
arrows facing up
No Gap
TORQUE TO:
Gap
2.8-3.4 Nm
(25-30 in-lb)
Check that the bars turn freely.
If there is excess hose in this
area, see the instructions on
changing hose lengths and
bleeding the system
5
a
rIGhT-hand FronT (optional)
To run Juicy Five moto-style (right-hand front), flip the clamps over so the arrows face up, then mount as in step 5.
Note: The Juicy Three can be run
either left or right. Just swap the
levers and install the clamp bolts
from the opposite side.
© SRAM Corporation • May 2006
mounT leverS: Juicy Three
Slide the lever onto the bar to the proper position.
Tighten the clamp bolt to the specified torque.
do not overtighten.
TORQUE TO:
4-5 Nm
(30-40 in-lb)
Flip the clamps
then mount
English
7