Package Contents; Preparing The Host Computer - Sony S-AIT Library CSM-20S Kurzanleitung

4
Remove screw 3 (M3 with nut) on the right side, as
illustrated.
5
Remove screws (M3) for drive on the top of the
unit, as illustrated.
Screws for drive 1
(one drive)
6
Store the screws on the rear of the unit, as
illustrated.
M4
16
Package Contents / Preparing the Host Computer

Package Contents

After opening the package, make sure that all the
following items are present.
Contact your dealer if anything is missing.
• S-AIT Library (1)
• Quick start guide (1)
• SCSI terminator (1)
• Bar code label sheets (2)
• Door lock keys (2)
• Release pin for front door (1)
• In addition to the above, other items may be included
• All the items included with the S-AIT Library are
Screws for drive 2
Download the Operating Instructions and device driver
(only two drives)
from the Sony Web site (http://www.sony.net/Products/
storagesolution/).
Preparing the Host
Computer
Prepare the host computer before installing the S-AIT
library.
1
2
For details about the software that can be used with the
S-AIT library and supported operating systems, contact
your dealer.
The S-AIT library is an LVD SCSI device, thus it does
not support single-ended. Make sure that you use an
LVD-compliant host bus adapter card.
Notes
in the package.
indicated on the package.
Make sure that a SCSI host adapter card is installed
in the host computer.
Install all the necessary software supporting the
unit on the host computer.
Note