Siemens SINUMERIK 840D sl Handbuch Seite 220

Anhang
A.1 Beispiel: Datei basesys.ini
; This is the range of dynamic IPs given out by the DHCP server
; Defaults should be sensible
;InternalDynRangeStart=192.168.214.10
;InternalDynRangeEnd=192.168.214.240
[LinuxBase]
; Keep size of /var/log/messages around this value (not followed
; exactly for performance reasons)
LogfileLimit=102400
; Protocol/Port pairs to open in the firewall
; (e.g., TCP/5900, UDP/514, ...)
;FirewallOpenPorts=TCP/5900
; If there is only one Ethernet interface, it's used by default as
; an external(company) network. Alternatively, usage as automation
; net (TCU boot support etc.) is possible by setting NetworkModel
; to "automation". (Only NCU, Service, and PCU20A variants!)
;NetworkModel=automation
; DisableSubsystems can be used to skip certain CFSes (= subsystems)
; a list of multiple names (separated by spaces) is possible
; a simple name means all CFSes with this name, an absolute path
; (e.g., /siemens/sinumerik/nck) exactly this one CFS
; with the special value "ALL", all subsystems can be disabled
;DisableSubsystems=nck
; Setting DisableDHCPD<INTERFACE> to 1 suppresses that a DHCP server
; is started on that interface
;DisableDHCPDeth0=1
;DisableDHCPDibn0=1
; If DisableNATRouting is set, the NCU won't forward from TCU or
; IBN net (eth0, ibn0) to external net (eth1)
;DisableNATRouting=1
; Properties of local time zone: names, offset, start and end day
; Some examples:
; Europe: WET0WEST,M3.5.0,M10.5.0
; CET-1CEST,M3.5.0,M10.5.0
; EET-2EEST,M3.5.0,M10.5.0
; USA: EST5EDT,M4.1.0,M10.5.0
; CST6CDT,M4.1.0,M10.5.0
; MST7MDT,M4.1.0,M10.5.0
; PST8PDT,M4.1.0,M10.5.0
44
Inbetriebnahmehandbuch, 11/2006, 6FC5397-1DP10-1AA0
Betriebssystem NCU