Resetting The Default Settings - G&D VisionXS-F-DP-UHR Installation Und Bedienung

Configuration

Resetting the default settings

This function is used to reset the default settings of the KVM extender. By perform-
ing this function, the default settings mentioned on page 21 are reactivated.
How to reset the default settings:
NOTE: Open the local OSD of the user module by pressing the
Alt + Num ) if you want to reset the local settings of the user module only instead of
the settings of the extender system.
1. Open the remote OSD of the computer module by pressing
(default:
Ctrl
Open the local OSD of the user module by pressing the
Alt + Num ) if you want to reset the local settings of the user module.
2. Select the row
press Enter .
3. Select the row
4. Confirm the security prompt or cancel the process.
1. In the menu, click on
2. Click on
System defaults
3. Select the scope of the recovery:
Reset all settings
 Reset all settings of the device.
Reset only local network settings
 Reset only local network settings.
Reset only KVM application settings
 Reset all settings except the local network settings.
4. Click on
Set system defaults
53 · G&D VisionXS-F-DP-UHR
+ ) if you want to reset the settings of the extender system.
Num
System setup (remote OSD) or
Set system defaults
System .
.
.
Console utility
and press .
Enter
local hotkey (default:
remote hotkey
local hotkey (default:
(local OSD) and