Wilo LON Betriebsanleitung Seite 54

English
Value range
Status
0
1
1
1
Default value: status = 1, value = 200 = 100.0%. The default value corresponds
to the setting which can be stored in the SCPTsetpoint configuration parameter
in a non-volatile manner.
Requested pump operating mode
network input SNVT_hvac_mode nviPumpOpMode
This input network variable is used to set an operating mode. If an operating
mode is set which is not defined or invalid, the pump remains in the current
mode.
Value range
Value
HVAC_AUTO
HVAC_MRNG_WRMUP
HVAC_PRE_COOL
HVAC_ECONOMY
HVAC_NUL
Default value: HVAC_AUTO
Pump Capacity
network output SNVT_lev_percent nvoPumpCapacity
This output network variable provides the current operating point of the pump
as percentage of the maximum setpoint.
When using an external pressure or temperature sensor, this variable provides
the sensor value as a percentage of the maximum sensor value.
48
Value
0 – 255
0
1 – 200
201 – 255
Function
Normal operation
Warm-up mode
Cooling mode
Energy-saving mode
Invalid
Function
STOP
STOP
0.5 – 100.0%
100.0%
Comments
Setpoint via nviPumpSetpoint
Maximum speed
Maximum speed
Setback operation speed
(pump type specific)
WILO AG 04/2007