Wilo LON Betriebsanleitung Seite 14

Output- Mand. NVT
Networkvariable Opt.
nvoStatus M SNVT_obj_status
nvoPumpCapacity M SNVT_lev_percent
nvoPressure O SNVT_press
nvoFlow O SNVT_flow_p
nvoEnergyConsum O SNVT_elec_kWh
nvo Power O SNVT_power
nvoPowerKilo O SNVT_power_kilo
nvoRuntime O SNVT_time_hour
nvoSpeed O SNVT_rpm
nvoFluidTemp O SNVT_temp_p
nvoControlMode M SNVT_dev_c_mode
Obj No. Send Min. Data Range
Heartbt / Send and Units
Ack Time
0 2 yes yes
1 3 yes yes -163.84
– 163.83 %
1 14 no yes -3276.8
– 3276.6 kPa
1 15 no yes 0 – 655.34 m
1 24 no yes 0 – 65535 kWh
1 22 no yes 0 – 6553.5 W
1 23 no yes 0 – 6553.5 kW
1 18 no yes 0 – 65535 h
1 16 no yes 0 – 65535 rpm
1 21 no yes -273.17
– 327.66 °C
1 5 yes yes ENUM 0 – 29
(device_c_mode_t)
Resolution Invalid Range and effective
Data resolution WILO
- invalid_id
invalid_request
disabled
electrical_fault
unable_to_measure
manual_control
in_alarm
0.005 % 0x7FFF 0 – 100.0%
Res: 0.2%
0.1 kPa 0x7FFF Range depends on
Pumptype
Res. :0.981 kPa
3 3
/h 0.01 m /h 0xFFFF Range depends on
Pumptype
Res : 0.1 m
1 kWh - 0 – 65535 kWh
Res: 1 kWh
0.1 W - 0 – 6553W
Res: min. 1 W
0.1 kW - 0 – 65.5 kW
Res: 0.1 kW
1 h - 0 – 65535 h
Res: 10 h
1 rpm - 0 – 65535 rpm
Res: min.1 rpm
0.01 °C 0x7FFF -50 °C – 205°C
Res : min. 0.1 °C
- 0xFF DCM_SPEED_CONST
DCM_PRESS_CONST
DCM_PRESS_COMP
DCM_PRESS_AUTO
DCM_NUL
Send when value
changes more than
Send upon nviRequest:
update
5 % of nroPump-
Char.pressMax
or 2 % of nroPump-
Char.speedMax resp.,
control mode changes
5 % of
nroPumpChar.pressMax
5 % of
nroPumpChar.flowMax
3
/h
1 kWh
10 % of max. Power
10 % of max. Power
10 h
2 % of nroPump-
Char.speedMax
5 °C
immediately