Transport And Interim Storage; Intended Use - Wilo LON Betriebsanleitung

NOTE: Useful information on using the product. It also draws attention to
potential problems.
2.2 Safety instructions for inspection and installation work
The safety instructions in the installation and operating instructions for the
entire unit should be observed for all work on the pump(s).
WARNING! Danger from electric shock
Any hazards from electrical current should be ruled out.
Work on the unit/pump(s) may only be carried at a mechanical standstill,
in electrically isolated condition and with appropriate tools.

3 Transport and interim storage

Inspect the pump/system for transport damage immediately upon arrival. Any
transport damage found must be reported to the carrier within the prescribed
periods.
CAUTION! Risk of damage to the IF-module!
Risk of damage due to improper handling during transport and storage.
• The IF-modules should be protected against humidity, frost and mechanical
damage during transport and temporary storage.
• They must not be exposed to temperatures outside the range of - 10 °C to
+ 70 °C.

4 Intended use

Wilo-Control IF-module LON, IF-module Stratos LON
The IF-module LON is used to connect electronically controlled glandless or glanded
pumps to a LON. The pump can be preset with setpoints, operating modes and data from
external sensors, and current operating data and fault signals can be transferred from the
pump via the LON bus.
At the same time the IF-module LON allows two pumps to be connected to form a
double pump via an additional DP interface. This interface is a separate device. It is not
a LON-based interface. That is why the LON bus for the double pump interface is not put
under strain and the slave pump can be equipped with an inexpensive IF-module PLR.
Installation and operating instructions Wilo-Control IF-module LON / IF-module Stratos LON
English
37