Brief Overview - Endress+Hauser iTEMP HART TMT162 Bedienungsanleitung

56

Brief overview

Using the following short form instructions you can commission your system easily and swiftly:
Safety notes
Installation
Display and operating elements
Commissioning
Quick Setup - fast entry into the unit configuration for standard
measurements
Safety message
Instructions and procedures in the operating instructions may require special precautions to ensure
the safety of the personnel performing the operations. Information that potentially raises safety
issues is indicated by safety pictograms and symbols. Please refer to the safety messages before
performing an operation preceded by pictograms and symbols, see chapter 1.5.
Though the information provided herein is believed to be accurate, be advised that the information
contained herein is NOT a guarantee of satisfactory results. Specifically, this information is neither
a warranty nor guarantee, expressed or implied, regarding performance; merchantability, fitness or
other matter with respect to the products; and recommendation for the use of the product / process
information in conflict with any patent. Please note that the manufacturer reserves the right to
change and / or improve the product design and specifications without notice.
#
WARNING
Failure to follow these installation guidelines could result in death or serious injury
► Make sure only qualified personnel perform the installation.
Explosions could result in death or serious injury
► Do not remove the housing cover in explosive atmospheres when the circuit is live.
► Before connecting a Model 275/375 HART
sure the instruments in the loop are installed in accordance with instrinsically safe or non-
incendive field wiring practices.
► Verify that the operating atmosphere of the transmitter is consistent with the appropriate
hazardous locations certifications.
► All housing covers must be fully engaged to meet explosion-proof requirements.
Process leaks could result in death or serious injury
► Do not remove the thermowell while in operation.
► Install and tighten thermowells and sensors before applying pressure.
Electrical shock could cause death or serious injury
► Use extreme caution when making contact with the leads and terminals.
Æ
Æ
Wiring
Æ
Æ
®
Communicator in an explosive atmosphere, make
TMT162
→ ä 58
→ ä 61
→ ä 64
→ ä 68
→ ä 74
Endress+Hauser