Endress+Hauser iTEMP HART TMT162 Bedienungsanleitung Seite 72

Operation
Measured
PV
values
Standard Matrix
Function
parameter
set-up
mode
Sensor type
Sensor 1
Sensor 1
Sensor type
Sensor 2
Sensor 2
Output
PV up
range value
Safety
Reaction
settings S1 <> S2
Display
Display
Diagnosis
Device status
Identification
Measuring
point
Service Security
locking
functions
72
PV value
Value Value
AO
in %
Sensor 1 Sensor 2
Min measurm
PV mode PV unit
range
2-wire
Cold External
Sensor
comp. S1
connect. S1
junction S1 temp. S1
2-wire
Sensor Cold External
connect. S2 comp. S2
junction S2 temp. S2
PV lo
Analog HART
Filter time
range value
output Output mode
Fault
Alarm Corros.
Ambient
condition hysteresis detection
alert
Decimal Display
Display text
places interval
Status Status Config.
Last
Sensor 1 Sensor 2 changed
diagnostic
Device infos
Tag Descriptor Message
Simulation Simulation Trim
Default
mode value 4 mA
values
The black highlighted function fields
are marking the Quick Setup menu.
®
Fig. 10: HART function matrix
5.3.2 FieldCare
FieldCare is a universally applicable service and configuration software based on FDT/DTM
technology. Connection is established by means of a HART
Detailed information is provided in the installation instructions of the FieldCare configuration
software (see chapter 'Documentation'). The DTMs available for the device also allow operation by
means of operating programs of other manufacturers that support FDT/DTM technology.
5.3.3 ReadWin
®
ReadWin 2000 is a universally applicable service and configuration software. Connection is made
®
using a HART modem, e.g. Commubox FXA191. The operating software offers the user the
following possibilities:
• Setup device functions
• Measured value visualization
• Device parameter data storage
• Measuring point documentation
NOTICE
Analog output
► The analog output is undefined when downloading the device function parameters from
®
ReadWin 2000 to the device.
Further in-depth information on operation via ReadWin
documentation of the software. ReadWin
following address:
www.endress.com/Readwin
RJ value
Max
RTD
measurm
connection
range
Offset Meas. unit
Value
sensor1 sensor1
sensor1
Offset Meas. unit
Value
sensor2 sensor2 sensor2
Num. resp. Poll
preams addr.
Over-/Under-
Mains filter
range alarm
Min. value S1 Max. value S2
Max. value S1
E+H Device
E+H Soft-
E+H serial no.
release
ware rev.
Trim
20 mA
®
2000
®
2000 can be downloaded free of charge from the
Serial no.
S1
Serial no.
S2
Max. Min.
Min. value S2
RJ value RJ value
Certificates Manufacturer Model Date
®
modem, e.g. Commubox FXA191.
®
2000 can be found in the online
TMT162
Hardware
rev.
Endress+Hauser