14
OPERATION
14.1
Adjustments before operation
14.1.1 Adjusting the riving knife
Open the two quick releases left and right at the vacuum
and reduce the protective flap down.
Using a wrench, loosen the nut slightly.
Adjust the riving knife so that the distance from the saw blade is'
3-8 mm.
Tighten the nut after adjustment firmly.
Close the safety door and lock it with the two quick releases.
NOTE: if the machine does not turn, it may be that the stop plate is not actuated the limit switch.
When the safety valve, press the stop plate a little towards the limit switch.
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
Zimmerer Tischkreissäge und Rollbahn / carpenter table saw and roller stand
Quick release
stop plate
limit switch
protective flap
nut
OPERATION
Seite 33
TS 400Z
TS 400ZAL