Operation; Operation Instructions - Holzmann KAP 305ECO Betriebsanleitung

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.

15.1 Operation instructions

Perform all machine settings with the machine being
 Do not look directly into the laser beam. Never direct the laser beam at people
or objects other than the workpiece.
 Do not deliberately point the laser beam at people.
 Only point the laser beam at insensitive workpieces with a dull surface. Wood
or rough surfaces are ideal for this. Shiny, reflective surfaces are not suitable
for using a laser since the laser beam could be directed at the user by the
reflective surfaces.
 Always switch off the laser when you have finished work at the ON/OFF switch
for the laser light.

Only switch on the laser beam if there is a workpiece on the mitre saw bench
 The machine has to be attached to the underground. For this purpose there are
4 borings at the ground plate, two at the front side and two at the back side.
Furthermore you can attach the machine to miter saw stands.
 Do not use damaged or warped saw blades.
 Replace the worn table insert.
 Select the appropriate saw blade for the material to be cut.
 Warning! Protective equipment must not use for the purpose of transport
 Use the saw only if the safety devices are functional, in good condition and in
the provided position.
 Do not remove offcuts or other workpiece parts from the sectional area, as long
as the machine with unprotected blade is moving.
 The workpiece must always be clamped to the saw table.
 Before each cutting operation make sure that the machine stands safely.
 Mark the cutting line on the workpiece.
 Set the angle of the cutting operation.
 To make a cut from the workpiece hold the laser along the marked line.
 Remove the workpiece only after the cut has been completed
HOLZMANN MASCHINEN GmbH
W A R N I N G
disconnected from the power supply!
A T T E N T I O N
www.holzmann-maschinen.at
N O T I C E
OPERATION
30
KAP 305ECO