Setting The Saw Blade Tilt / Slant - Holzmann TS 400Z Originalbetriebsanleitung

 Rotate the locking lever counterclockwise loose.
 Now you can move the drive unit / blade up to the desired height with the lever tube.
 Secure with the locking lever, the drive unit firmly.
 Loosen the locking screw and push back the lever tube again.
Tighten the set screw.

INFO: In the top position of the drive unit of the locking lever can be pulled in the direction of
arrow and like a ratchet loosely be

14.2.6 Setting the saw blade tilt / slant

The saw blade can range from 0° - 45° inclined.
NOTE:
When loosening the set screw in the 90 ° position slide
the drive unit through the lateral motor focus down.
The saw blade on the work table tilts thus unexpectedly
quickly to the side in the slope.
Loosen the set screw down to the frame and tilt the drive

unit / blade to the desired slope.
 Tighten the fixing screw good.
To set the 0 ° and 90 ° stop just loosen the lock nuts on the

screws on the frame and adjust with the screws from the
crossroad.
Then screw the locknuts securely.

HOLZMANN MASCHINEN GmbH
rotated.
www.holzmann-maschinen.at
Zimmerer Tischkreissäge und Rollbahn / carpenter table saw and roller stand
locking screw
locking screw
locknut
Screw
OPERATION
Seite 35
TS 400Z TS 400ZAL