Maintenance; Saw Blade Change - Holzmann TS 400Z Originalbetriebsanleitung

15

MAINTENANCE

No cleaning and maintenance with a connected machine!
Before carrying out any maintenance or cleaning work the machine is to
be taken from the power supply!
The machine is low maintenance and contains little parts that must undergo a maintenance oper-
ator.
Failures or defects which may affect the safety of the machine, must be rectified immediately.
Repair work may only be carried out by qualified personnel!
The complete and utter cleaning ensures a long life for the machine and represents a safety re-
quirement.
After each shift the machine and all its parts must be thoroughly cleaned! The complete and utter
cleaning ensures a long life for the machine and represents a safety requirement
Check regularly that all warning and safety instructions on the machine available and properly
legible condition.
Check before every use the perfect condition of the engine.
When storing the machine should this not be stored in a humid room and must be protected
against the influence of weather conditions.
The elimination of defects does your dealer

Repair work may only be carried out by qualified personnel!

15.1 maintenance

15.1.1 Saw blade change

ATTENTION: Use safety gloves!
 Lower the blade as described in 14.2.5 all the way down.
 Open the two side quick release and fold down the protec-
tive flap.
 Insert the supplied Allen key into the drive shaft.
 With the 17mm wrench, the nut can be unscrewed.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Zimmerer Tischkreissäge und Rollbahn / carpenter table saw and roller stand
A T T E N T I O N
drive shaft
Allen key
MAINTENANCE
Seite 38
TS 400Z TS 400ZAL