13.2.2 mount saw blade guard cover
The blade guard cover is screwed to the two flat bars to the
er.
The self-locking nuts tighten so hard that the whole thing with
the lifting handle (3) can still move.
13.2.3 mount the rip fence
With the two screws holding bracket is screwed into the
threads on the guide plate.
The aluminum profile is pushed into 2 possible guide to
the sliding block at the angle bracket.
With the locking lever can be clamped variable.
The
locking lever can be set by tightening direction of the
arrow like a ratchet (ratchet).
13.2.4 Power connector
At the main switch box is below the connector for the power
supply.
HOLZMANN MASCHINEN GmbH
Locking lever
www.holzmann-maschinen.at
Zimmerer Tischkreissäge und Rollbahn / carpenter table saw and roller stand
Flat iron
angle bracket
ASSEMBLY
Seite 31
TS 400Z
TS 400ZAL