Operation; Operation Instructions; Adjustments - Holzmann HBS 230ECO Betriebsanleitung

15

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.

15.1 Operation instructions

Perform all machine settings with the machine being
disconnected from the power supply!
 Long and overhanging workpieces must be supported additionally!
 Never switch the machine on while pressing the workopiece against the
saw band. Allow the machine to reach full speed before start cutting.
 Check the saw band tension before any operation!
 Sägebandführung erst einstellen, nachdem Sägeband, Sägebandlauf und
Sägebandspannung überprüft wurden!
 Sawband guide can be adjusted only after the sawband, sawband
tracking and the sawband tension has been checked.
 The push stick must always be used when the distance between saw
band and and rip fence is less than 150mm.
 Check the belt and tighten if necessary
 Overtightening the belt can cause the motor to bind and not start. It can
also damage motor bearings!
 In advanced wear of, replace belt.
 Belt and pulleys may not come into contact with grease, oil or other
lubricants
 Loosen the belt for a long break

15.2 Adjustments

Tilting the table:
 Loosen the wing nut (a)
 Set the table to the desired angle
 Fix the wing nut
 The desired angle is expediently to be checked by test cuts
Blade tension:
 For setting turn the saw
band tension knob (b)
 Saw band quick release
lever:
ON=tensioned
OFF=tension released
HOLZMANN MASCHINEN GmbH
W A R N I N G
www.holzmann-maschinen.at
N O T I C E
OPERATION
27
HBS 230ECO